Front Stair Renovation Time-Lapse Start to Finish | Old Concrete to New Vinyl and Composite Deck
Video by The Fixer · 2 moments used in Oak Valley Designs's DIY guides · 23:37 long

Moments in this video
- 13:17–15:33 Prepare Stair Base and Pour Concrete Pad
From Deck Stairs, Step 1: Prepare the Stair Location
Attach a pressure-treated 2x4 to the front edge of the deck, ensuring it is level and securely fastened. This 2x4 will serve as the attachment point for the stair stringers. Next, create a concrete pad for the base of the stairs. Dig a rectangular trench, approximately 6 inches deep and the desired width/length for the stair landing area. Construct a wooden form using 2x4s to outline the concrete pad, ensuring it is level and square. Add a layer of gravel within the form for drainage and stability. Lay wire mesh reinforcement within the form before pouring the concrete. Mix Quikrete concrete in a wheelbarrow to a consistent, workable texture. Pour the concrete into the form, spreading it evenly and leveling it with a screed board. Use a concrete float to smooth the surface, then allow it to cure. Once cured, carefully remove the wooden form boards.
- 13:17–15:33 Prepare Stair Base and Pour Concrete Pad
From How to Pour a Concrete Landing Pad for Deck Stairs, Step 1: Excavate Area
Attach a pressure-treated 2x4 to the front edge of the deck, ensuring it is level and securely fastened. This 2x4 will serve as the attachment point for the stair stringers. Next, create a concrete pad for the base of the stairs. Dig a rectangular trench, approximately 6 inches deep and the desired width/length for the stair landing area. Construct a wooden form using 2x4s to outline the concrete pad, ensuring it is level and square. Add a layer of gravel within the form for drainage and stability. Lay wire mesh reinforcement within the form before pouring the concrete. Mix Quikrete concrete in a wheelbarrow to a consistent, workable texture. Pour the concrete into the form, spreading it evenly and leveling it with a screed board. Use a concrete float to smooth the surface, then allow it to cure. Once cured, carefully remove the wooden form boards.
Guides that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

