How to Add a Stair Runner | Breezing Through Blog

0:01 going to show you how to add a stair runner to your stairs first measure the width of the carpet that you're going to be using and then cut pieces of tape to match that width I used a piece of painting tape as my guide I then measured the center of each step and marked the spot with a piece of tape you can also Mark the outside edges of where you want your carpet to be on each step I then centered each piece of carpet tape onto each step I used an electric staple gun to then attach the carpet to the stairs it is important to make sure that the carpet is very tight during this process you'll need to pull the carpet tight while you're stapling it and do the same thing as you lay it over the carpet tape there were a few times where I had to use pliers to remove Staples and redo a section or a step for these stairs I got two lengths of the same Runner once IID used all of One Runner I cut off the trim from one end of each Runner and then slightly overlaid them so you couldn't see a gap

0:46 I made sure to line up the pattern when I was doing this I repeated this process all the way to the bottom of the stairs here's the finished result hello there's still an echo but there's probably a third of the echo there used to be follow for more tools and supplies linked in my bio