Install Board and Batten Trim

What happens in this clip

Attach the pre-cut trim pieces to the wall following your design. The video shows a brief glimpse of a nail gun (specifically a Flex 23-gauge pin nailer) being used, which is a modern and efficient method for securing trim. Start by installing the horizontal boards, ensuring they are level, then add the vertical battens, maintaining consistent spacing. Use an adhesive caulk or construction adhesive on the back of the trim pieces for a stronger bond before nailing. The video showcases the walls with the board and batten already installed, highlighting the completed framing before the finishing touches.

Goal: Securely attach all trim pieces to the wall to form the board and batten design.

What's used

Tools

• Air Compressor (if pneumatic nail gun)
• Level
• Nail Gun Flex
• Stud Finder
• if desired.

Materials

• Construction Adhesive (e.g.
• Liquid Nails)
• Finish Nails

About the full video

This project details the process of creating an elegant board and batten accent wall using modern techniques and materials, focusing on precise installation and a seamless finish. The video primarily highlights the finishing stages, including caulking and painting, but the comprehensive steps provided cover the entire process from planning to final paint application.

Step 4 of 6: Install Baseboard (if applicable)

If your design includes a baseboard below the battens, now is the time to install it. Measure and cut the baseboard material to fit the length of the wall sections. Position the baseboard so its top edge meets the bottom of the vertical battens. Ensure it is level and flush against the wall. Secure the baseboard to the wall studs using finishing nails or screws. If the baseboard is replacing an existing one, remove the old one first. Ensure a tight fit against the wall and the battens.

Open this step in the guide

Other videos for this step

• Install Vertical Battens with Spacer Blocks