Prepare and Clean Stair Treads

What happens in this clip

Begin by thoroughly cleaning the stair treads. You can use a microfiber cloth or any suitable cloth, optionally combined with a handheld vacuum, to remove all dust and loose dirt. The goal is to ensure the entire stair surface is clean and completely dry. This is crucial for the adhesive on the back of the carpet treads to stick properly. Avoid using any cleaning products that might leave a greasy residue, such as Pledge or Pine-Sol, as this can compromise the adhesive bond.

Goal: Clean the entire surface of each stair tread to remove all dust and loose dirt, ensuring it is nice and dry for optimal adhesive bonding.

What's used

Tools

• Handheld vacuum
• Microfiber cloth

About the full video

This project provides step-by-step instructions for easily installing carpet treads onto stairs using strong adhesive tape. It covers preparing the stairs by cleaning them, marking alignment with painter's tape, and then securely attaching the self-adhesive carpet treads for a secure and streamlined look.

Step 3 of 7: Clean Carpet Tread Underside and Stair Surface

If the carpet is slightly loose, carefully pull it back further if possible. Remove any old, loose adhesive, dust, debris, or grime from both the underside of the carpet's backing and the wooden stair tread surface using a stiff brush and a clean cloth. For stubborn residue, a mild degreaser or adhesive remover might be necessary, followed by a thorough wipe-down with a damp cloth and allowing to dry completely.

Open this step in the guide

Every video in How to Fix Popping Noises from Adhesive Carpet Treads on Wood Stairs

1. Step 1: Inspect Carpet Tread Noise

   • 0:00–0:17 Identify Squeak Location
   • 2:21–3:48 Diagnose Creaking Causes

2. Step 2: Examine Carpet Tread Adhesion

   • 0:00–0:04 Inspect Damaged Carpet Edge
   • 0:06–0:17 Inspect Loose Stair Nosing
   • 0:36–0:40 Apply Adhesive to Secure Carpet

3. Step 3: Clean Carpet Tread Underside and Stair Surface

   • 0:09–0:45 Prepare and Clean Stair Treads (this video)
   • 0:07–0:17 Apply Adhesive to Carpet and Subfloor
   • 0:00–0:05 Prepare the Loose Carpet Section

4. Step 4: Apply New Adhesive

   • 0:07–0:17 Apply Adhesive to Carpet and Subfloor
   • 0:04–0:08 Apply Spray Adhesive
   • 0:04–0:08 Apply Carpet Adhesive

5. Step 5: Reinforce Loose Carpet Edges (Optional)

   • 0:29–0:34 Secure Carpet Edge with Staples
   • 0:08–0:11 Secure Carpet at Bullnose with Stapler
   • 0:11–0:14 Secure Carpet with Staples

6. Step 6: Address Sub-Surface Creaks

   • 3:29–3:39 Eliminate Squeaks from Treads
   • 0:14–0:34 Fix Squeaks from Underneath with Shims
   • 1:24–2:44 Fix Squeaks on Carpeted Stairs

7. Step 7: Test Repaired Treads

   • 11:15–11:37 Final Inspection
   • 0:07–0:10 Test Stair Stability
   • 4:28–5:00 Test the Repaired Stairs