How To Build a Deck | Composite Stairs & Railings (4 of 5)
Video by Lowe's Home Improvement · 2 moments used in Oak Valley Designs's DIY guides · 5:38 long

Moments in this video
- 2:20–3:14 Mark and Cut Stringers
From How to Lay Out and Cut Deck Stair Stringers, Step 2: Select Stringer Material
Place the 2x12 treated lumber boards, which will become the stringers, on sawhorses. Using a framing square equipped with stair gauges (set to the previously calculated rise and run), mark the steps onto the board. Start by marking the top run at the corner of the plank, then slide the square along the plank to mark both the rise and run for each subsequent step. Continue marking until you have the correct number of steps for your stringer. Once marked, use a circular saw to cut along the lines, stopping short of the corners to avoid overcutting. Finish the cuts cleanly at the corners with a hand saw. Use this first cut stringer as a template to mark and cut the remaining stringers, ensuring consistency across all stair supports.
- 3:14–3:53 Attach Stringers and Secure Lower Posts
From Deck Stairs, Step 3: Attach Stringers to Deck
Install a 2x8 board directly below the deck joist where the stairs will attach; this provides a solid anchoring point. Secure the cut stringers to this 2x8 using metal stringer hangers and appropriate fasteners. Ensure the stringers and hangers are flush with the top of the 2x8. Next, attach the outer stringers to the previously installed newel posts at the bottom of the stairs. Drill pilot holes near the ends of the boards before driving screws to prevent splitting. Then, install any remaining interior stringers, securing them to the 2x8 at the top and to the footers at the bottom with suitable bracing, anchors, and carriage bolts, ensuring they are level and plumb.
Guides that use this video
More from the Oak Valley Designs DIY Hub
Read the guide Browse all guides
Planning this project? Shop Oak Valley Designs.

