Attach Clamps to the Banister Post

What happens in this clip

Take the two wooden clamps from the kit. Position one clamp at the top and the other at the bottom of the desired banister post. Use a wrench to securely tighten the bolts on the clamps, ensuring they are firmly attached to the banister without causing damage. The video demonstrates this process by tightening the bolts until the clamps are snug.

Goal: Securely fasten the wooden clamps to the top and bottom of the banister post.

What's used

Tools

• Banister post
• Wooden Clamps KidSmartLiving.com
• Wrench

About the full video

This project demonstrates an easy, no-drill method for installing baby safety gates onto stairway banisters. It utilizes a specialized installation kit composed of clamps and a wooden board to create a secure mounting surface without damaging the existing woodwork. The kit is versatile, fitting various banister styles and compatible with several baby gate brands.

Step 3 of 6: Attach Banister Mounting Hardware

Follow the instructions specific to your banister mounting kit. This typically involves wrapping straps around the banister and securing them, or attaching a mounting post that the gate will connect to. Make sure the hardware is tightened sufficiently to prevent any movement, but not so tight that it could crack or damage the banister material. Some kits may require drilling small pilot holes into a wooden banister; if so, proceed with caution and use the correct bit size.

Open this step in the guide

Every video in How to Install a Baby Gate on Stairs with a Banister on One Side and a Wall on the Other

1. Step 1: Determine Gate Placement

   • 1:05–1:12 Mark and Drill Wall Holes
   • 2:14–3:30 Mount Gate Assembly Brackets
   • 0:08–0:09 Determine the position of the upper hinge

2. Step 2: Install Wall-Side Mounts

   • 0:54–1:08 Drill Holes and Install Wall Cups
   • 0:00–0:50 Install Wall Brackets Securely

3. Step 3: Attach Banister Mounting Hardware

   • 0:27–0:33 Attach Clamps to the Banister Post (this video)
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

4. Step 4: Mount the Gate

   • 11:15–11:22 Mount and Adjust the Gate
   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 3:44–4:19 Secure Mounting Brackets (Side 2)

5. Step 5: Adjust and Test Latches

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:11–1:59 Verify Gate Functionality and Safety
   • 3:49–4:22 Verify Security and Functionality

6. Step 6: Final Safety Check

   • 3:49–4:22 Verify Security and Functionality
   • 3:27–3:34 Final Review and Finishing Touches
   • 1:11–1:59 Verify Gate Functionality and Safety