Install Baby Gate and Verify Compatibility

What happens in this clip

With the mounting board securely in place, you can now install your baby safety gate according to its manufacturer's instructions. The video demonstrates the completed installation of a baby gate onto the system. The kit is compatible with most standard banister post styles, including square-top and bottom, round-top and square-bottom, and round-top and bottom posts. There are also kits available for thinner stairway spindles. Ensure your gate's mounting hardware is less than 1.5 inches wide for compatibility with this specific kit. Brands like Cardinal and KidCo are specifically mentioned as compatible.

Goal: Mount the baby gate to the newly installed wooden board and ensure overall compatibility.

What's used

Tools

• Baby safety gate Cardinal
• KidCo
• Mounting board (from kit) KidSmartLiving.com
• Stairway banisters
• Stairway spindles

About the full video

This project demonstrates an easy, no-drill method for installing baby safety gates onto stairway banisters. It utilizes a specialized installation kit composed of clamps and a wooden board to create a secure mounting surface without damaging the existing woodwork. The kit is versatile, fitting various banister styles and compatible with several baby gate brands.

Step 3 of 6: Attach Banister Mounting Hardware

Follow the instructions specific to your banister mounting kit. This typically involves wrapping straps around the banister and securing them, or attaching a mounting post that the gate will connect to. Make sure the hardware is tightened sufficiently to prevent any movement, but not so tight that it could crack or damage the banister material. Some kits may require drilling small pilot holes into a wooden banister; if so, proceed with caution and use the correct bit size.

Open this step in the guide

Every video in How to Install a Baby Gate on Stairs with a Banister on One Side and a Wall on the Other

1. Step 1: Determine Gate Placement

   • 1:05–1:12 Mark and Drill Wall Holes
   • 2:14–3:30 Mount Gate Assembly Brackets
   • 0:08–0:09 Determine the position of the upper hinge

2. Step 2: Install Wall-Side Mounts

   • 0:54–1:08 Drill Holes and Install Wall Cups
   • 0:00–0:50 Install Wall Brackets Securely

3. Step 3: Attach Banister Mounting Hardware

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility (this video)

4. Step 4: Mount the Gate

   • 11:15–11:22 Mount and Adjust the Gate
   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 3:44–4:19 Secure Mounting Brackets (Side 2)

5. Step 5: Adjust and Test Latches

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:11–1:59 Verify Gate Functionality and Safety
   • 3:49–4:22 Verify Security and Functionality

6. Step 6: Final Safety Check

   • 3:49–4:22 Verify Security and Functionality
   • 3:27–3:34 Final Review and Finishing Touches
   • 1:11–1:59 Verify Gate Functionality and Safety