Mark and Drill Wall Holes

What happens in this clip

With the gate temporarily held in place, use a pencil to mark the exact position of the four wall cups on the wall or door frame. Also, mark the center point within each wall cup where the screw will go. After marking, remove the gate from the opening. Then, use a drill to carefully punch holes at each of the marked screw points.

Goal: Create pilot holes for wall anchors and screws.

What's used

Tools

• Cumbor Baby Gate Cumbor
• Drill Bit
• Drill
• Pencil

About the full video

This DIY project provides step-by-step instructions for securely hardware mounting a Cumbor baby gate, which is highly recommended for safety, especially when installing the gate at the top of stairs. The process includes unpacking components, measuring and adding extensions if needed, marking and drilling holes, installing wall anchors and cups, tightening the gate, and finally, testing its functionality.

Step 1 of 6: Determine Gate Placement

Before drilling, decide on the precise mounting points. For the wall side, hold the gate at the desired height and mark the screw hole locations. For the banister side, use the banister mounting kit's template or the gate's hardware as a guide to mark the attachment points, taking into account any angled surfaces or required spacing for the mounting kit.

Open this step in the guide

Every video in How to Install a Baby Gate on Stairs with a Banister on One Side and a Wall on the Other

1. Step 1: Determine Gate Placement

   • 1:05–1:12 Mark and Drill Wall Holes (this video)
   • 2:14–3:30 Mount Gate Assembly Brackets
   • 0:08–0:09 Determine the position of the upper hinge

2. Step 2: Install Wall-Side Mounts

   • 0:54–1:08 Drill Holes and Install Wall Cups
   • 0:00–0:50 Install Wall Brackets Securely

3. Step 3: Attach Banister Mounting Hardware

   • 0:27–0:33 Attach Clamps to the Banister Post
   • 0:14–0:26 Understand the No-Holes Banister Installation Kit
   • 0:43–1:10 Install Baby Gate and Verify Compatibility

4. Step 4: Mount the Gate

   • 11:15–11:22 Mount and Adjust the Gate
   • 2:15–2:40 Install Spindles and Final Gate Mounting
   • 3:44–4:19 Secure Mounting Brackets (Side 2)

5. Step 5: Adjust and Test Latches

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:11–1:59 Verify Gate Functionality and Safety
   • 3:49–4:22 Verify Security and Functionality

6. Step 6: Final Safety Check

   • 3:49–4:22 Verify Security and Functionality
   • 3:27–3:34 Final Review and Finishing Touches
   • 1:11–1:59 Verify Gate Functionality and Safety