Final Installation and Snap into Place

What happens in this clip

Once both torsion springs are installed and all wires are tucked away, gently straighten the LED recessed trim so it is centered and aligned with the ceiling opening. With the trim straight, push it upward into the recessed housing. Apply even pressure until you feel and hear the trim snap firmly into place, indicating it is fully seated and flush with the ceiling. Restore power at the circuit breaker and test the new LED light.

Goal: Securely seat the LED trim flush with the ceiling and test the light.

About the full video

This project provides verbose step-by-step instructions for installing an LED Dimmable 5in. or 6in. Retrofit Kit into an existing recessed lighting fixture. The process includes removing the old lamp and trim, adjusting the lamp holder bracket, making the electrical connection with a lamp holder adapter, installing torsion springs, and finally snapping the new LED trim securely into the housing. Emphasized throughout is the critical safety precaution of turning off power before beginning any electrical work.

Step 7 of 7: Finishing Touches

If your recessed lights come with separate trim pieces or covers, install them now according to the manufacturer's instructions. These typically snap or twist into place. Remove any debris, dust, or drywall scraps from the work area and ensure the stairwell is clean and safe.

Open this step in the guide

Every video in How to Install Recessed Step Lights in a Stairwell Wall

1. Step 1: Plan Light Layout

   • 0:34–0:49 Mark Light Placement
   • 5:10–6:00 Integrate Stair Niche Lights
   • 0:00–0:27 Planning and Safety

2. Step 2: Cut Fixture Openings

   • 0:04–0:10 Mark and Cut Drywall Hole
   • 0:00–0:01 Trace Cutout with Template
   • 0:17–0:22 Cut the Ceiling Hole

3. Step 3: Run Electrical Wire

   • 0:59–1:18 Run Electrical Wires
   • 4:35–5:25 Run New Electrical Wires
   • 1:57–2:46 Run Electrical Wires to Light Fixtures

4. Step 4: Connect Fixtures to Power

   • 2:01–3:49 Connect Electrical Wires
   • 0:41–0:51 Connect Electrical Wires
   • 0:00–0:02 Connect Electrical Wires to Fixture

5. Step 5: Install Light Fixtures

   • 4:51–5:50 Mount the Fixture in the Ceiling
   • 0:18–0:22 Install Recessed Light
   • 0:11–0:18 Connect and Install Recessed Light Fixture

6. Step 6: Restore Power and Test

   • 0:00–0:30 Test and Finalize Installation
   • 1:36–1:44 Restore Power and Test Functionality
   • 0:24–0:26 Test New Lighting System

7. Step 7: Finishing Touches

   • 0:16–0:33 Install Decorative Trim
   • 2:19–2:48 Install Trims
   • 2:19–2:28 Final Installation and Snap into Place (this video)