Restore Power and Test Functionality

What happens in this clip

After the fixture is fully installed, return to your circuit breaker panel and switch the power back on. Insert a working light bulb into the new fixture. Finally, flip the wall switch to test if your new light fixture is functioning correctly. If it doesn't work, retrace your steps to check connections and ensure the correct breaker was reset.

Goal: Verify the new light fixture is working properly

What's used

Tools

• Circuit Breaker Panel
• Light Bulb
• Light Switch

About the full video

This project provides step-by-step instructions on how to safely replace a temporary construction light fixture with a new, finished light fixture. It covers essential safety precautions, proper wire preparation, electrical connections, and final installation steps.

Step 6 of 7: Restore Power and Test

Once all fixtures are installed and connections are made, return to the electrical panel and turn the breaker back on for the circuit you were working on. Test each light to ensure it illuminates correctly. If any light does not work, turn the power off again and re-check all wiring connections.

Open this step in the guide

Every video in How to Install Recessed Step Lights in a Stairwell Wall

1. Step 1: Plan Light Layout

   • 0:34–0:49 Mark Light Placement
   • 5:10–6:00 Integrate Stair Niche Lights
   • 0:00–0:27 Planning and Safety

2. Step 2: Cut Fixture Openings

   • 0:04–0:10 Mark and Cut Drywall Hole
   • 0:00–0:01 Trace Cutout with Template
   • 0:17–0:22 Cut the Ceiling Hole

3. Step 3: Run Electrical Wire

   • 0:59–1:18 Run Electrical Wires
   • 4:35–5:25 Run New Electrical Wires
   • 1:57–2:46 Run Electrical Wires to Light Fixtures

4. Step 4: Connect Fixtures to Power

   • 2:01–3:49 Connect Electrical Wires
   • 0:41–0:51 Connect Electrical Wires
   • 0:00–0:02 Connect Electrical Wires to Fixture

5. Step 5: Install Light Fixtures

   • 4:51–5:50 Mount the Fixture in the Ceiling
   • 0:18–0:22 Install Recessed Light
   • 0:11–0:18 Connect and Install Recessed Light Fixture

6. Step 6: Restore Power and Test

   • 0:00–0:30 Test and Finalize Installation
   • 1:36–1:44 Restore Power and Test Functionality (this video)
   • 0:24–0:26 Test New Lighting System

7. Step 7: Finishing Touches

   • 0:16–0:33 Install Decorative Trim
   • 2:19–2:48 Install Trims
   • 2:19–2:28 Final Installation and Snap into Place