Apply Anti-Slip Strip

What happens in this clip

Carefully peel back a section of the protective backing from one end of a pre-cut anti-slip strip. Align the exposed adhesive side of the strip along the edge of the stair, ensuring it is straight and centered. Slowly press the exposed part of the strip onto the stair, working from one end to the other, while gradually peeling off the rest of the backing. Once the entire strip is in place, firmly press down along its entire length with your hands to ensure good adhesion and to remove any trapped air bubbles.

Goal: Secure the anti-slip strip firmly to the stair edge

What's used

Tools

• Hands
• Squeegee

Materials

• Anti-slip staircase guard strip

About the full video

This project demonstrates the simple process of installing anti-slip "staircase guards" to prevent slips and falls on stairs. It involves preparing the stair surface, applying self-adhesive strips to the edge of each step, and trimming them to fit, significantly enhancing stair safety.

Step 4 of 5: Apply Anti-Slip Tape or Strips

Measure and cut the anti-slip tape or strips to fit the desired area on each tread, typically along the front edge (nosing). Ensure the surface of the tread is clean and dry. Peel back the backing of the tape and carefully apply it to the tread, pressing down firmly from the center outwards to eliminate air bubbles and ensure good adhesion. For longer strips, overlap slightly if necessary, or butt them up against each other for a continuous surface. Ensure edges are well-adhered to prevent peeling.

Open this step in the guide

Every video in How to Make Oak Stairs Less Slippery

1. Step 1: Clean the Oak Stair Treads

   • 0:03–0:07 Prepare and Clean Stairs
   • 0:45–0:50 Scrub and Agitate the Wood Surface
   • 0:35–0:44 Apply Wood Cleaner to Stairs

2. Step 2: Sand the Stair Treads

   • 2:06–2:52 Sand Stair Treads and Risers
   • 1:01–1:17 Sand Stair Treads
   • 1:05–1:18 Vacuum Dust and Perform Fine Sanding

3. Step 3: Apply Anti-Slip Coating

   • 0:46–0:59 Spray Clear Anti-Slip Coating
   • 0:11–0:25 Apply First Coat of Non-Slip Spray
   • 2:27–3:10 Apply Paint to Stairs

4. Step 4: Apply Anti-Slip Tape or Strips

   • 1:12–1:19 Prepare Steps and Apply Non-Skid Strips
   • 0:02–0:06 Apply Anti-Slip Strip (this video)
   • 1:14–1:23 Apply Non-Skid Strips to Steps

5. Step 5: Install Anti-Slip Treads or Risers

   • 0:18–0:37 Install Lower Stair Treads and Risers