Mark and Drill Bottom Pilot Holes (Side 1)

What happens in this clip

Position the assembled gate against the wall where the gate will be installed, and use it as a guide. Place one of the prepared bottom mounting brackets on the wall, aligning it with the lower bar of the gate. Using a pencil, mark the exact locations where the pilot holes need to be drilled through the bracket. Then, using the corded drill and the selected drill bit, carefully drill pilot holes into the wall. Ensure the drill bit angles slightly upwards, following the orientation of the mounting hardware.

Goal: Create accurately placed pilot holes for the bottom mounting bracket on the first side of the opening.

What's used

Tools

• Assembled gate Regalo
• Bottom mounting bracket (assembled) Regalo
• Corded drill Black & Decker
• Drill bit
• Pencil
• Safety glasses

About the full video

This project provides verbose step-by-step instructions for installing a Regalo Extra Tall Top of Stair Metal Walk-Through Safety Gate (Model #1255 B DS, Black) at the top of a staircase. The process includes assembling the gate, preparing and securing the mounting hardware to the wall, adjusting the gate's width and fit, and performing final checks for smooth and secure operation.

Step 3 of 6: Drill Pilot Holes

Select a drill bit that is slightly smaller than the diameter of the screws provided with the baby gate. For each marked screw position, drill a pilot hole into the solid wood. The depth of the pilot hole should be sufficient to accommodate the length of the screw, but not so deep that it compromises the integrity of the wall.

Open this step in the guide

Every video in How to Install a Hardware-Mounted Baby Gate at the Top of Stairs

1. Step 1: Identify Mounting Surfaces

   • 0:24–0:31 Install Lower Wall Mounts (First Side)
   • 0:13–0:18 Prepare Mounting Boards
   • 0:23–0:32 Install Wall-Mount Baby Gate

2. Step 2: Mark Bracket Positions

   • 2:59–3:10 Mark, Drill, and Secure Top Mounting Bracket (Side 1)
   • 1:21–1:35 Position Gate and Mark Wall
   • 1:26–1:45 Position Gate and Mark Wall

3. Step 3: Drill Pilot Holes

   • 1:05–1:12 Mark and Drill Wall Holes
   • 1:50–2:02 Mark and Drill Bottom Pilot Holes (Side 1) (this video)
   • 1:18–1:48 Drill Pilot Holes and Insert Anchors

4. Step 4: Attach Mounting Brackets

   • 1:43–1:50 Secure Wall Brackets
   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 3:14–3:37 Mount the Bracket to the Wall

5. Step 5: Attach Gate to Brackets

   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 1:48–1:55 Mount the Gate into Brackets
   • 3:37–4:15 Install the Safety Gate

6. Step 6: Adjust and Test Gate Functionality

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:30–2:19 Final Assembly and Testing
   • 3:49–4:22 Verify Security and Functionality