Position Gate and Mark Wall

What happens in this clip

Carefully position the assembled gate within your doorway or opening. Ensure it is level and centered for optimal appearance and function. Once the gate is in the desired position, use a pencil to trace the outline of each spindle rod's base (the part that will press against the wall) directly onto the wall or door frame. Then, mark the exact center of each traced outline; this is where the wall cups will be installed.

Goal: Determine precise mounting locations for wall cups

What's used

Tools

• Level
• Pencil

About the full video

This project provides a step-by-step guide for installing an extra-wide walk-through safety gate. It covers initial measurement, frame assembly, door placement, extension addition (if necessary), marking and drilling for wall cups, securing the gate with spindle rods, and finally, adjusting the door swing mechanism.

Step 2 of 6: Mark Bracket Positions

Place the baby gate in the desired position at the top of the stairs. Ensure it is level and that there is adequate clearance for the gate to swing open. Hold the mounting brackets against the wall or post at the pre-determined locations. Use a pencil to mark the exact center of each screw hole for both the top and bottom brackets on each side of the opening.

Open this step in the guide

Every video in How to Install a Hardware-Mounted Baby Gate at the Top of Stairs

1. Step 1: Identify Mounting Surfaces

   • 0:24–0:31 Install Lower Wall Mounts (First Side)
   • 0:13–0:18 Prepare Mounting Boards
   • 0:23–0:32 Install Wall-Mount Baby Gate

2. Step 2: Mark Bracket Positions

   • 2:59–3:10 Mark, Drill, and Secure Top Mounting Bracket (Side 1)
   • 1:21–1:35 Position Gate and Mark Wall
   • 1:26–1:45 Position Gate and Mark Wall (this video)

3. Step 3: Drill Pilot Holes

   • 1:05–1:12 Mark and Drill Wall Holes
   • 1:50–2:02 Mark and Drill Bottom Pilot Holes (Side 1)
   • 1:18–1:48 Drill Pilot Holes and Insert Anchors

4. Step 4: Attach Mounting Brackets

   • 1:43–1:50 Secure Wall Brackets
   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 3:14–3:37 Mount the Bracket to the Wall

5. Step 5: Attach Gate to Brackets

   • 3:44–4:19 Secure Mounting Brackets (Side 2)
   • 1:48–1:55 Mount the Gate into Brackets
   • 3:37–4:15 Install the Safety Gate

6. Step 6: Adjust and Test Gate Functionality

   • 17:06–18:29 Test Gate Functionality and Latch
   • 1:30–2:19 Final Assembly and Testing
   • 3:49–4:22 Verify Security and Functionality