Shim Gaps from Underside
From How to Fix Squeaky Stairs from Underneath with Shims and Glue Blocks · Step 2 of 6 · Video by Today's Homeowner with Danny Lipford

Showing 0:15–0:38 of the source video. Watch the full video with every moment.
What happens in this clip
If you have access to the underside of your stairs, locate the area where the squeak occurs. This is typically caused by a small gap between the stair tread and its support structure. Obtain a few wooden shims, which are thin, tapered pieces of wood. Gently tap one or more shims into the gap using a hammer until the gap is filled and the movement causing the squeak is eliminated. To prevent the shims from dislodging and to add further stability, apply a bead of good quality construction adhesive around the shims and into any remaining small voids using a caulk gun. This will help seal the shims in place and prevent future movement.
Goal: Eliminate squeaks by shimming and securing gaps from below.
What's used
Tools
- Caulk Gun
- Hammer
Materials
- Construction Adhesive Titebond
- Gorilla Glue Construction Adhesive
- Wooden Shims
- Plastic shims
About the full video
This project provides practical solutions for silencing squeaky stairs, addressing different scenarios based on accessibility and flooring type. It covers methods for fixing squeaks from the underside using shims and construction adhesive, and from the top for carpeted or hardwood stairs using screws and cosmetic finishing.
Step 2 of 6: Prepare Shim Material
Examine the area where the squeak originates. You'll likely see a small gap between the tread and riser, or between these components and the staircase stringer. Using a utility knife or a handsaw, cut thin pieces of wood (like scraps from 1x lumber or pre-made wood shims) that are slightly longer than the gap. The goal is to create pieces that can be tapped into these gaps to eliminate movement.
Every video in How to Fix Squeaky Stairs from Underneath with Shims and Glue Blocks
Step 1: Locate Squeaky Tread
- 0:14–0:34 Fix Squeaks from Underneath with Shims
- 0:13–0:20 Locate Squeaky Floor Section
- 2:45–5:32 Identify Squeak Causes and Mark Fixings
Step 2: Prepare Shim Material
- 0:14–0:34 Fix Squeaks from Underneath with Shims
- 0:15–0:38 Shim Gaps from Underside (this video)
- 3:09–3:51 Tighten Loose Risers with Shims
Step 3: Apply Wood Glue
- 6:40–7:13 Apply Wood Glue (Back Risers)
- 0:22–0:34 Apply Wood Glue
- 6:22–6:49 Apply 5-Minute Wood Adhesive
Step 4: Insert and Secure Shims
- 4:46–5:44 Attach Support Blocks and Secure Wedges
- 4:08–4:28 Final Gap Filling and Tread Reinforcement
- 3:09–3:51 Tighten Loose Risers with Shims
Step 5: Test for Squeaks
- 4:28–5:00 Test the Repaired Stairs
- 0:14–0:34 Fix Squeaks from Underneath with Shims
- 5:45–6:01 Test the Repaired Stairs
Step 6: Clean Up
- 10:52–11:00 Clean Up Mess
- 13:42–14:26 Clean Glue Squeeze-out
How to Fix Squeaky Stairs from Underneath with Shims and Glue Blocks
This project outlines the steps to fix squeaky stairs from underneath by using shims and glue blocks to secure the treads and risers.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.

