Connect Interconnect Cable to LED Strip/Panel

What happens in this clip

Finally, connect the remaining unused end of your interconnect cable to the input connector of your LED panel or flexible strip. Once this connection is made, and assuming the power supply is plugged in, the motion sensor will likely be activated immediately, causing your LEDs to turn on instantly as shown in the video.

Goal: Complete the electrical circuit to power the LED lights

What's used

Tools

• Interconnect Cable Inspired LED
• LED Panel or Flexible Strip Inspired LED

About the full video

This project provides step-by-step instructions for installing and configuring an Inspired LED Motion Sensor to control low-voltage LED flex strips or panels, creating a hands-free lighting system. Ideal for spaces like pantries, closets, and drawers, the system automatically turns LEDs on and off in response to motion, such as opening and closing a door. The installation covers connecting the power supply, LED lighting, mounting the sensor, and adjusting its time delay.

Step 4 of 6: Connect LED Strips and Motion Sensor

Follow the specific wiring diagram provided with your LED strip kit and motion sensor. Typically, this involves connecting the strips in series using the provided connectors or by soldering. Connect the output of the final LED strip to the input of the motion sensor. Ensure all connections are secure and properly insulated to prevent short circuits. The motion sensor will then be connected to the power source.

Open this step in the guide

Every video in How to Install Motion-Sensor LED Strip Lights on Stair Treads

1. Step 1: Plan LED Strip Placement

   • 0:00–0:02 Plan and Gather Components
   • 0:00–0:19 Install Flexible LED Strip Lighting
   • 5:35–6:58 Plan Light Placement and Spacing

2. Step 2: Prepare Stair Treads

   • 0:00–0:01 Prepare Staircase for LED Installation
   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:02 Prepare Stair Surface

3. Step 3: Install LED Strips

   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:01–0:04 Apply LED Strip Lights to Treads
   • 0:00–0:19 Install Flexible LED Strip Lighting

4. Step 4: Connect LED Strips and Motion Sensor

   • 0:09–0:09 Connect Controller, Sensors, and Power Supply
   • 0:41–0:45 Connect LED Strips to Motion Detector
   • 1:22–1:36 Connect Interconnect Cable to LED Strip/Panel (this video)

5. Step 5: Mount Motion Sensor and Power Supply

   • 13:17–14:27 Mount Motion Sensors and Electronic Box
   • 3:50–4:30 Mount and Test the Motion Sensor
   • 3:25–4:32 Install and Wire Motion Sensors

6. Step 6: Test the System

   • 0:02–0:14 Test Motion Sensor Functionality
   • 0:10–0:11 Test Functionality and Observe Results
   • 0:07–0:10 Test Electrical Components