Test Motion Sensor Functionality

What happens in this clip

Once the lights are mounted, test their motion-sensing capabilities. In a dimly lit or dark environment, move in front of the installed lights. The lights should automatically turn on when motion is detected within their sensor's range. After a period of no detected motion (typically 15-20 seconds, depending on the model), the lights should automatically turn off to conserve battery life. The video effectively demonstrates this as a person enters a dark room and approaches cabinets, causing the lights to illuminate automatically.

Goal: Verify automatic activation and deactivation of lights

About the full video

This project provides instructions on how to install and utilize rechargeable, motion-sensing LED strip lights to illuminate various areas, such as under cabinets, inside closets, or above work surfaces. The lights are easily mounted using adhesive magnetic strips, offering convenient and energy-efficient lighting that automatically activates upon detecting motion in dark environments. The guide also demonstrates the recharging process for the battery-powered lights.

Step 6 of 6: Test the System

Plug in the power supply. Walk past the motion sensor to confirm that the LED lights activate. Observe the sensitivity and range of the motion sensor, adjusting its position or settings if necessary. Test to see if the lights turn off after the programmed delay. Ensure all LEDs illuminate evenly and that there are no flickering or dead spots. Check all connections one last time.

Open this step in the guide

Every video in How to Install Motion-Sensor LED Strip Lights on Stair Treads

1. Step 1: Plan LED Strip Placement

   • 0:00–0:02 Plan and Gather Components
   • 0:00–0:19 Install Flexible LED Strip Lighting
   • 5:35–6:58 Plan Light Placement and Spacing

2. Step 2: Prepare Stair Treads

   • 0:00–0:01 Prepare Staircase for LED Installation
   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:02 Prepare Stair Surface

3. Step 3: Install LED Strips

   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:01–0:04 Apply LED Strip Lights to Treads
   • 0:00–0:19 Install Flexible LED Strip Lighting

4. Step 4: Connect LED Strips and Motion Sensor

   • 0:09–0:09 Connect Controller, Sensors, and Power Supply
   • 0:41–0:45 Connect LED Strips to Motion Detector
   • 1:22–1:36 Connect Interconnect Cable to LED Strip/Panel

5. Step 5: Mount Motion Sensor and Power Supply

   • 13:17–14:27 Mount Motion Sensors and Electronic Box
   • 3:50–4:30 Mount and Test the Motion Sensor
   • 3:25–4:32 Install and Wire Motion Sensors

6. Step 6: Test the System

   • 0:02–0:14 Test Motion Sensor Functionality (this video)
   • 0:10–0:11 Test Functionality and Observe Results
   • 0:07–0:10 Test Electrical Components