Mount and Test the Motion Sensor

What happens in this clip

Find a suitable location to mount the PIR motion sensor. The presenter chose to mount his sensor in his laundry room, positioned between his washer and dryer, facing the room's entrance to capture motion effectively. Use the provided mounting tape or screws to secure the sensor. Once mounted, connect the power supply to an outlet and the LED light strip to the motion sensor's output. Test the system by walking into the detection area. The LED lights should turn on. Wait for the preset time (e.g., 2 minutes, as set by the presenter) and observe the lights turning off automatically. This confirms successful installation and functionality.

Goal: Securely mount the motion sensor and verify its proper operation with the LED light strip.

What's used

Tools

• LED Light Strip
• Mounted PIR Motion Sensing Switch EShine

About the full video

This DIY project demonstrates how to install a PIR (Passive Infrared) motion-sensing switch for an LED light strip. The switch automatically turns on the LED lights when motion is detected and turns them off after a user-adjustable preset time. The project covers unpacking the switch, understanding its specifications, adjusting the timer, and potentially modifying the connectors by soldering if they don't match the existing LED strip or power supply. Finally, it shows how to mount and test the installed system.

Step 5 of 6: Mount Motion Sensor and Power Supply

Choose a location for the motion sensor that has a clear line of sight to the stairs and will effectively detect movement. Mount it using its adhesive backing or screws, ensuring it's firmly in place. Mount the power supply near an electrical outlet, again using adhesive or screws. Ensure that all wiring is neatly routed and secured using cable clips or ties to prevent it from hanging loosely or becoming a hazard.

Open this step in the guide

Every video in How to Install Motion-Sensor LED Strip Lights on Stair Treads

1. Step 1: Plan LED Strip Placement

   • 0:00–0:02 Plan and Gather Components
   • 0:00–0:19 Install Flexible LED Strip Lighting
   • 5:35–6:58 Plan Light Placement and Spacing

2. Step 2: Prepare Stair Treads

   • 0:00–0:01 Prepare Staircase for LED Installation
   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:02 Prepare Stair Surface

3. Step 3: Install LED Strips

   • 0:10–0:12 Install LED Strips on Stair Treads
   • 0:01–0:04 Apply LED Strip Lights to Treads
   • 0:00–0:19 Install Flexible LED Strip Lighting

4. Step 4: Connect LED Strips and Motion Sensor

   • 0:09–0:09 Connect Controller, Sensors, and Power Supply
   • 0:41–0:45 Connect LED Strips to Motion Detector
   • 1:22–1:36 Connect Interconnect Cable to LED Strip/Panel

5. Step 5: Mount Motion Sensor and Power Supply

   • 13:17–14:27 Mount Motion Sensors and Electronic Box
   • 3:50–4:30 Mount and Test the Motion Sensor (this video)
   • 3:25–4:32 Install and Wire Motion Sensors

6. Step 6: Test the System

   • 0:02–0:14 Test Motion Sensor Functionality
   • 0:10–0:11 Test Functionality and Observe Results
   • 0:07–0:10 Test Electrical Components