Shape and Texture the Patch

What happens in this clip

After the concrete patch has partially set (approximately 15 minutes, depending on conditions), use the margin trowel to carefully shave off any excess material and refine the shape. Pay close attention to re-establishing the desired radius on the edge to match the existing concrete. Once the desired shape is achieved, take a clean, damp sponge (squeezed to remove excess water) and gently blend the new patch into the existing concrete. Then, move the sponge in a single direction across the patch to create a broom-like texture, mimicking the finish of the surrounding concrete. This helps the repair blend seamlessly and appear natural.

Goal: Smooth, shape, and texture the patch to blend with existing concrete

What's used

Tools

• Bucket
• Margin Trowel
• Concrete edger
• Sponge

Materials

• Clean Water

About the full video

This DIY project demonstrates how to repair chipped or spalled concrete surfaces using Quikrete Vinyl Concrete Patcher. The process involves preparing the damaged area by moistening it, mixing the concrete patcher to a Play-Doh consistency, applying it to fill the chips, and then shaping and texturing the patch to seamlessly blend with the existing concrete.

Step 5 of 6: Shape and Finish the Surface

While the repair compound is still wet and workable, use a damp trowel or float to smooth the surface. Work from one side to the other, feathering the edges of the repair to blend with the surrounding concrete. Aim to recreate the original rounded or square edge profile of the step. Use a damp brush or sponge for final texturing if needed to match the surrounding concrete.

Open this step in the guide

Every video in How to Repair a Chipped Concrete Step Edge

1. Step 1: Clean the Chipped Area

   • 0:12–0:55 Clean and Prepare the Damaged Area
   • 0:46–1:13 Clean Out Debris and Loose Chunks
   • 1:36–3:50 Clean Out Loose Concrete and Debris

2. Step 2: Undercut the Edge (if necessary)

   • 0:46–1:13 Clean Out Debris and Loose Chunks
   • 1:36–3:50 Clean Out Loose Concrete and Debris
   • 0:43–1:02 Prepare Damaged Concrete and Install Forms

3. Step 3: Mix the Concrete Repair Compound

   • 0:39–0:49 Mix Patching Cement
   • 1:41–1:54 Mix Concrete Patching Compound
   • 1:03–2:18 Mix the Concrete Patcher

4. Step 4: Apply the Repair Compound

   • 1:55–2:11 Apply Concrete Patch to Chips
   • 1:15–4:04 Apply Two-Part Epoxy Filler
   • 1:32–1:46 Fill Damaged Areas

5. Step 5: Shape and Finish the Surface

   • 3:40–5:58 Smooth and Finish Concrete Step Repair
   • 0:52–1:02 Smooth and Finish Concrete Patch
   • 3:15–5:02 Shape and Texture the Patch (this video)

6. Step 6: Cure the Repair

   • 0:37–0:46 Cure and Protect the Repaired Area
   • 0:28–0:29 Allow Compound to Cure
   • 11:58–12:06 Cure and Protect Repaired Steps