Final Inspection and Testing
From Squeaky Stair Repair · Step 7 of 7 · Video by Cameron & Sadie
Showing 0:27–0:32 of the source video.
What happens in this clip
Once all the screws are in place and the construction adhesive has been applied and allowed to cure according to the manufacturer's instructions, perform a final inspection and test. Walk up and down the stairs, paying close attention to any remaining squeaks. While the video notes that some minimal squeaking might still occur, the overall noise level should be significantly reduced compared to the initial state. This step confirms the effectiveness of the repairs and allows for any final adjustments if necessary.
Goal: Confirm the reduction or elimination of stair squeaks.
About the full video
This project details how to fix squeaky stair treads after removing carpet. It involves cleaning the stairs, screwing down the treads to securely fasten them to the stringers and risers, and then applying construction adhesive (tread lock) to seal the edges and further prevent movement, significantly reducing or eliminating squeaks.
Step 7 of 7: Test the Repair
Thoroughly test each step where a repair was made by walking on it. Listen for any remaining squeaks. If the noise persists, re-examine the area and consider if a different approach or reinforcement is needed.
Other videos for this step
Squeaky Stair Repair
This project addresses the common issue of squeaky stairs by identifying the source of the noise and applying targeted fixes to eliminate it. The process involves a systematic approach to diagnose the cause, which can range from loose treads or risers to friction between wood components, and then implementing appropriate solutions such as tightening fasteners, shimming gaps, or applying lubricants.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.