Test the Light Fixture
From Recessed Staircase Lighting · Step 7 of 8 · Video by eztv online
Showing 3:42–3:55 of the source video.
What happens in this clip
After the light fixture is fully installed and all connections are secure, proceed back to your electrical panel. Carefully flip the circuit breaker back to the 'on' position to restore power to the circuit. Then, return to the room and turn on the light switch to verify that your new light fixture is functioning correctly. If the light turns on, you have successfully completed the installation!
Goal: Verify the light fixture operates correctly
What's used
Tools
- Circuit breaker Siemens
- Light switch
About the full video
This project guides you through the process of installing a new ceiling light fixture, emphasizing essential safety steps like securing the ground wire and taping wire connectors for enhanced protection against electrical hazards.
Step 7 of 8: Test the System
Once all connections are made and fixtures are installed, go to the main electrical panel and turn the power back on to the circuit. Test each light by operating the associated switch. Verify that all lights illuminate properly and consistently. If any light does not work, immediately turn off the power and re-check all wiring connections.
Other videos for this step
Recessed Staircase Lighting
This project involves planning the layout, safely running electrical wiring, cutting holes in the wall, installing the light fixtures, and connecting them to a power source. It's a moderately complex electrical project that requires careful attention to safety and building codes.
Read the full guide Browse all guides
Planning this project? Shop Oak Valley Designs.